Loading...

Inner Layers Operator - 2nd shift

The Inner Layer Wet Process Operator uses wet chemistry to etch circuit images and apply oxide to panels.  Operators develop resist from layers, etch to remove copper that is not protected by resist, and strip off resist that was left from develop and etch cycles to expose circuit.  Process panels through developer to remove excess resist on all unexposed areas of panel. The schedule for this opening is 3-11:30 PM, Monday - Friday with rotating overtime as needed usually on Saturday mornings.

 

PRINCIPAL DUTIES AND RESPONSIBILITIES:

  • Check ph to ensure it remains within established limits
  • Run break test to determine conveyor speed for developing
  • Check developing solution for proper concentration as specified by MPP
  • The resist strip process is the removal of photo resist exposing the copper circuits
  • Monitor and maintain proper solution levels on all rinse sumps
  • Change solutions per tank maintenance
  • Verify solution temperatures
  • Ability to process first article panel
  • Monitor to insure uniform and constant flow of work through appropriate resist stripper
  • Follow all preventive maintenance schedules
  • Follow all requirements for waste treatment
  • Inspect panels for defects
  • Cupric etching is a process whereby exposed copper is dissolved into a cupric based etchant
  • Process panels per inner layer MPP
  • Maintain automatic chemical feed and bleed systems
  • Monitor and maintain proper solution levels on all rinse sumps
  • Change solutions per tank maintenance or preventive maintenance
  • Verify etchant temperatures
  • Monitor etchant specific gravity
  • Run spray nozzle test and etch break test daily
  • Process first article panels
  • Measure spacing and line width with microscope
  • Set and monitor conveyor speed depending on copper thickness
  • Monitor process to insure uniform and constant flow of work through etcher
  • Follow all preventive maintenance schedules
  • Follow all requirements for waste treatment
  • Inspect panels for defects
Required Skills:
  • Functional English skills (reading, writing, speaking)
  • Attention to detail
  • Adherence to all safety requirements of the position

*Unicircuit is a drug-free facility.  All candidates must be able to pass a drug test.

Required Experience:

Experience: 0-2 Years Relevant Experience. Industry experience preferred, not required. Work experience in handling chemicals preferred, not required.

Must be eligible to work on defense and satellite programs subject to ITAR Regulations. Therefore, candidates must be a U.S. Citizen or a U.S. Permanent Resident ('Green Card').

Unicircuit is a VEVRAA/Federal Contractor and EEO/AA Employer, including disabled and veterans.

Location: Littleton
Category: Regular Full-time
Tracking Code: 2013334

Have questions?

Contact Us

Need Help?

In accordance with the Americans with Disabilities Act and Executive Order 11246, Anaren provides reasonable accommodation to applicants with disabilities. Applicants who need different or additional accommodations for any part of the application and hiring process are encouraged to contact our Human Resources Department by calling 315-432-8909 or writing 6635 Kirkville Road, East Syracuse, NY 13057.

 

Anaren is an equal opportunity employer. All qualified applicants will receive consideration for employment without regard to race, color, religion, sex, sexual orientation, gender identity, genetics, national origin, age, disability or protected veteran status. Anaren is a drug-free workplace.